Quote:
Originally Posted by LGAFF
Well, I tried checking the gasket compression with a new set of gaskets...could not see a mark...but looks like that was because they are new. Took some Gorilla tape and put it down, the Inj Hs are leaving deep marks on the tape.....so Gorilla Tape is 1/4 the thickness of Jerrys Gaskets.....I think I am good....any thoughts.
I believe the warp is in the center of the IH, so if you tighten down one side of the IH is amplifies the warp
I am think get them milled and ready to go
|
Lee, If you are anything like me they will be fine until you are 300 miles away from home. I would get them shaved and be done with it.