Quote:
Originally Posted by pushrod-v8
What are the pins and their location on the ALCL to test for trouble codes? I am referring to the paper clip method. If I remember correctly they are the slots in the upper right corner but I am may be wrong.
I started my z yesterday and not more than 100 feet later the car began to stumble and almost cut off. After warming up it went away and began to drive fine except for a slight bog in 2nd gear under load.
The car has about 68K on the clock and there seem to be a lot of original parts on the car. I have replaced the coils and wires. The prior owner installed new FIC injectors that are ethanol compliant.
Thanks ahead of time!
|
That's where they are on my 82, and I would imagine that they are the same for our Z's....
Not being too familiar with the LT5, I would assume that you start from the beginning. Such as, fuel delivery, spark (ignition), grounds, etc.,etc. If the engine doesn't have a code, you would need to go through each system to narrow down the source of the problem....JMO