ZR-1 Net Registry Forums - View Single Post

Funracer · 05-03-2015

Easy to get the pumps out. Just lift and turn slowly and it will come out.
Try to pay attention to which way you turn and lean the pump assembly when you
take it out. The install is the reverse and can be frustrating if you have not done it before.

Actually swapping the pumps is straight forward. My only suggestion is to not reuse the plastic
(or nylon whatever they are made of) ratchet clips on the fuel lines. They are apparently single use
clips. I reused them and had to pull the pumps again almost immediately to repair a slipped fuel line.
Just use small stainless screw clamps.

How long? First time 2-3 hours if you go slow. Also put some masking tape on the forward edge of the painted gas cap well. When you pull the pumps you can scrape the paint in that area. Don't ask me how
I know that. Good luck!

05-03-2015	#9
Funracer Join Date: Oct 2011 Location: Shalimar, FL Posts: 192	Re: Full engine Power light Easy to get the pumps out. Just lift and turn slowly and it will come out. Try to pay attention to which way you turn and lean the pump assembly when you take it out. The install is the reverse and can be frustrating if you have not done it before. Actually swapping the pumps is straight forward. My only suggestion is to not reuse the plastic (or nylon whatever they are made of) ratchet clips on the fuel lines. They are apparently single use clips. I reused them and had to pull the pumps again almost immediately to repair a slipped fuel line. Just use small stainless screw clamps. How long? First time 2-3 hours if you go slow. Also put some masking tape on the forward edge of the painted gas cap well. When you pull the pumps you can scrape the paint in that area. Don't ask me how I know that. Good luck!