View Single Post
Old 07-11-2015   #5
Dynomite
 
Dynomite's Avatar
 
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,816
Default Re: Installing Stainless Steel Brake Hoses

I understand the feeling of slipping a wrench rounding off a hex.....I would try large Vice Grips at that point to hold the bottom steel line hex. The Break line Hex is larger and an open end may allow you to apply enough torque to break the fitting loose. Otherwise another Large Vice Grip. I have never tried heat on a brake line but heat would prolly not bother as you are discarding the rubber line anyway

Quote:
Originally Posted by Dmod81 View Post
When mine were frozen I used pb blaster CRC freeze off over the course of a couple of days (with tapping for vibration). I also used heat very carefully. Mine ended up rounding off too so I used vise grips on a couple.
We are thinking exactly alike as I was posting at the same time

Last edited by Dynomite; 07-11-2015 at 11:35 PM.
Dynomite is offline   Reply With Quote