ZR-1 Net Registry Forums - View Single Post - Request

BigIke · 11-01-2015

That's it, the MC push rod. Thanks, going to try and put a small split clamp around the shaft near the eye to limit hydraulic release bearing (HBR) travel.

Got a 7mm steel and a 1/4" teflon split clamp.

Thanks again,
Jay

11-01-2015	#3
BigIke Join Date: Aug 2014 Location: Montgomery TX Posts: 263	Re: Request - Master Cylinder Push Rod Diameter That's it, the MC push rod. Thanks, going to try and put a small split clamp around the shaft near the eye to limit hydraulic release bearing (HBR) travel. Got a 7mm steel and a 1/4" teflon split clamp. Thanks again, Jay