ZR-1 Net Registry Forums - View Single Post

efnfast · 11-27-2015

Paul, I don't even know where to start.
I was told the Ram stuff would work with my new to me Fidanza. Wrong.
The shims for the release bearing wouldn't fit the input shaft.
Not enough shims were provided.
The shims would not get us to the required tolerances. Three was too little, four was too much.
The provided lines rubbed a hole in themselves on the PP. Tear it apart again and BUY 45 degree elbows from Ram.
The clutch slips.
All told, my mechanic had about 40 hours invested into the install.
That's why I'm looking for recommendations in another post.

11-27-2015	#7
efnfast Join Date: Nov 2011 Location: Dunbarton NH Posts: 7,583	Re: Clutch Paul, I don't even know where to start. I was told the Ram stuff would work with my new to me Fidanza. Wrong. The shims for the release bearing wouldn't fit the input shaft. Not enough shims were provided. The shims would not get us to the required tolerances. Three was too little, four was too much. The provided lines rubbed a hole in themselves on the PP. Tear it apart again and BUY 45 degree elbows from Ram. The clutch slips. All told, my mechanic had about 40 hours invested into the install. That's why I'm looking for recommendations in another post.