Re: ECM And Ignition Module Availability/ replacement
Quote:
Originally Posted by -=Jeff=-
Was thinking about this today and thought it could use a bump..
Just curious on the challenges on this.. I know Jerry is working on something..
|
Still working on it. We hit a long delay when one of the sub-contractors was obligated on another project. Back on the project now and making steady progress. One of the more obvious challenges in the initial phase is developing the receiver connectors that are molded into the OE DIS. The priority for electrical connectors is to make it all the same as the OE DIS within cost feasibility parameters. The 14 pin connector would be better if the female side was on a wire lead of about 6" in length, so that has been taken into account.
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.
|