[Zrracer]

This is the LPE kit I am installing. I have done a Shinnoda/means kit years ago. As it was going to be done at the factory it was very straight forward and very well done. It fitted the car and used the existing attachment points. I will try and include a picture below.
Today I went from boat shop to boat shop looking for someone who has had great experience with fiberglass. I finally was directed to a car guy with lots of experience. He then referred me to another shop. I took the quarter panels to him. One was good one was bad. We made a deal for Him To start tomorrow. He is an older guy like me. He does not want to do the install of the kit. He is willing to take the rear cover off and redo it and get it right though. I suspect he will do the instal though. Even if he does not I can have the rest of the kit installed and have him do the necessary adjustments. He is going to prime it also.
I want the kit primed and hung on the car first. Jerry had problems with pin holes on his front piece. My quarters have the same issue. My conversation today put me at ease with the pinholes. He claims he will do 2 coats of polyester and that will stop the pinholes. I hope so.
He does want to do the paint when I am ready. He promises zero tape lines anywhere on the car. Hand sanding everything from blocking to 4 coats of clear.
Oh well,
I just hope after the costly first try I can get the kit whipped into shape and problem free. Oh yea, I am going to have the OEM pieces removed to allow him to fit the kit pieces.
I will post pictures as the kit gets done and hung.
I then will be addressing the engine which has not run for 10 years. I will then Yank the interior and get that all done while the painting gets done. I suspect I will then need a lot of final touches to get it done.
I now have to redo my timeline which was a foolish 6 months to do to a I have no idea when it’s getting done.
Robin