Quote:
Originally Posted by XfireZ51
Ignition is controlled by the ECM and is based on RPM x MAP. Without sensors, u have a bunch of codes. Whether the motor would even start is questionable. It certainly would be in “limp home” mode. What u are describing is using an ignition control system, so that’s what u should use.
|
Looked into the MSD 6010 again today as a ls coil ignition swap option with crank nose reluctor and trigger .
Does anyone know the lt5 cam sensor trigger and reluctor setup ?
The msd requires a cam signal matching the stock ls1 triggering .
Anyone know if lt5 cam signals match ls1?