[Tyler Townsley]

You have the thought process down but the specific steps could use some work.

1. Compression check.
2. Run the car, park it and look at the plugs they should be uniform in appearance if not then chase fuel/spark on that cyl.
3.Take a good known plug and one cyl at a time unplug the wire, plug in the plug, lay it on the plenum and start the car. The spark should be the same on every cyl if not then you know which coil pack/wire to chase for problems.
4. There is a DIS checker and should you suspect the dis of falling apart I can lend it to you. You need some kind of a scope to look at the signals to verify its falling apart.
5. If you pull the plenum then you can check the injectors by pulling fuel rail up, crank the car and look at the spray pattern.
6. If you have a suspect cyl you can eliminate spark with step 2 and check fuel by swaping injectors from cyl to cyl, this requires pulling the plenum but you get pretty good at in with practice.
7. Listen for the vacuum pump at the left front of the car. You should hear it cycle for a couple of seconds when the key is first turned on the go quiet for at least 5-10 minutes. Both failing to pull the vacuum, on start and an continuly cycling pump signal problems that will cause what you describe.



Let us know what you find.

Tyle