ZR-1 Net Registry Forums - View Single Post

XfireZ51 · 01-28-2008

If you are interested in learning about the PID controls, have a read of the attached paper. Don't be surprised if it takes a few run thrus' to grasp what they do. Actually making the changes to the cal will solidify for you how these controls help in fine tuning the behavior of the motor. This paper was written for a TBI system but the operating principles and results are very applicable even to an LT5.

01-28-2008	#64
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,686	Re: LT5 ECM Tuning thread If you are interested in learning about the PID controls, have a read of the attached paper. Don't be surprised if it takes a few run thrus' to grasp what they do. Actually making the changes to the cal will solidify for you how these controls help in fine tuning the behavior of the motor. This paper was written for a TBI system but the operating principles and results are very applicable even to an LT5. Last edited by XfireZ51; 03-08-2024 at 02:06 PM.