Hi all! Just catching up, I didn?t see these posts!
Thanks for your support with my project? it?s starting to take shape now, rear brake lines have been replaced (fronts okay for now) and I?m waiting on discs and calipers. Once they are done I should be able to drive to the pub! 😁
Annoyingly (off camera) I?m still chasing a misfire?
New fuel pumps, fuel filter, injectors
New coils, leads, plugs
New crank sensor
All vac lines tested and are working
All grounds cleaned including the block grounds
5 gallons of 98 Ron fuel in a clean tank
Code 31 and consistent misfire whether the engine is hot or cold
Frustrating!
I?m starting to run out of ideas now! But I?m thinking it could actually be the cam sensor which may have died when I got the car up to temp after 18 years of being laid up
I?ve got new o2 sensors, map sensor and a new IAC valve on the way. Hopefully I can source a cam sensor (I?ve contacted Phil). If it still doesn?t run properly after all that I might need to borrow an ECM from a UK owner to test? Any ideas?
