[DaveK]

Originally Posted by WVZR-1

I'm quite confident the K&N # is RB-0720. The flange where it attaches to the "intake tubes" is NOT straight, it has a small angle to it. I measured mine dimensionally and used their calculator and its a "dead match"! Mine is an SLP commonly referred to as the "Claw" I believe.

Here's a link to the dimensions, you should be able to confirm them. I used their main page and the "by dimension" calculator on the left. I used only the exact dimensions of OD, Length and ID of intake. The flange angle is/was unknown!

http://www.knfilters.com/search/prod...x?Prod=RB-0720

I believe that SLP provides some spacers for the fit to the "upper shroud" and you don't use any of their hardware. I don't recall any clearance issues. A clearance issue could be caused by the "angle" of the mounting flange not being "rotated" to the correct orientation on the intake. Use two of your air cleaner "thumb screws" and fit the assembly to your shroud. Looks substantially better NOT using their hardware.

That looks like a perfect match! Thanks for the detailed response and info on the clearance issues.