Quote:
|
Originally Posted by SC UL8R1990
Seems the little power key hole is loose. If you go all the way clockwise (full power) the power light comes on then goes off. Basically you have to back off a little just to make sure it stays in full power. As you drive along i can see where the key work its way out of that spot again due to vibration / spirited driving.
Is there a way to adjust this or can we replace the "ignition" behind the plastic dash piece it sits in?
thanks again everyone, i will be detailing the Z for my dad tomorrow so ill get some pics up for you guys.
|
if you take your time, you can remove the cylinder and pull it apart to fix the 'fingers' inside.
I did this to my 90 as I had the same issue.. all is good now