ZR-1 Net Registry Forums - View Single Post

08-12-2008

Jagdpanzer,

After installing these I would say that I like them and did have to trim a few which they do say is okay and I did not have to cut them too much for the close fit areas on the headers. I was not able to install all due to the length of the bolts for a few due to clearance and had to use studs with nuts or short bolts. Without looking again I would say 3 total that I could not use. There were some challenges and cussing to get some of the clips on as there is not much clearance in some areas for easy access as you know. To get them just right if you want to snug up against the header a little bit of adjustment is needed to the bolt to make tighter, etc., but not much due to 12 point flexibility.

08-12-2008	#3
HAWAIIZR-1 Guest Posts: n/a	Re: Stage 8 Locking Header Bolts Jagdpanzer, After installing these I would say that I like them and did have to trim a few which they do say is okay and I did not have to cut them too much for the close fit areas on the headers. I was not able to install all due to the length of the bolts for a few due to clearance and had to use studs with nuts or short bolts. Without looking again I would say 3 total that I could not use. There were some challenges and cussing to get some of the clips on as there is not much clearance in some areas for easy access as you know. To get them just right if you want to snug up against the header a little bit of adjustment is needed to the bolt to make tighter, etc., but not much due to 12 point flexibility.