ZR-1 Net Registry Forums - View Single Post

XfireZ51 · 09-02-2008

Jerry,

I appreciate your $.02. The IHs I had were already ported but to 34mm. I opened them up to 36-36.5mm. However, the Plenum was matched to the IH and then the cylinder head to the IH. The gaskets were from FlatOut Racing based on their 36mm template. I did trim gaskets to match as close that I could while leaving material where I thought it needed it.
However, good tips for next time. So far, my repair is holding.

09-02-2008	#18
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,686	Re: IH gasket coolant leak w Pics Jerry, I appreciate your $.02. The IHs I had were already ported but to 34mm. I opened them up to 36-36.5mm. However, the Plenum was matched to the IH and then the cylinder head to the IH. The gaskets were from FlatOut Racing based on their 36mm template. I did trim gaskets to match as close that I could while leaving material where I thought it needed it. However, good tips for next time. So far, my repair is holding. Last edited by XfireZ51; 09-02-2008 at 07:21 PM.