ZR-1 Net Registry Forums - View Single Post

IowaZR-1 · 09-14-2008

it can be done without a plenum pull......been there.......done that....can't remember for sure but you might have to pull the pulley off...if so make a special wrench to put it back on....weld a 16 inch long 1/2 bar to a socket on the side leaving the hole open thru it....an allen wrench will fit thru to hold the shaft as you tighten the nut

09-14-2008	#12
IowaZR-1 Join Date: Feb 2006 Location: Iowa aka "one big cornfield" Posts: 339	Re: Experiencing electrical failure it can be done without a plenum pull......been there.......done that....can't remember for sure but you might have to pull the pulley off...if so make a special wrench to put it back on....weld a 16 inch long 1/2 bar to a socket on the side leaving the hole open thru it....an allen wrench will fit thru to hold the shaft as you tighten the nut Last edited by IowaZR-1; 09-14-2008 at 10:29 AM.