View Single Post
Old 01-02-2009   #14
Sgreg
 
Sgreg's Avatar
 
Join Date: Aug 2006
Location: Texas
Posts: 518
Default Re: Original Factory NIB LT5 Thermostat Housing!

Quote:
Originally Posted by limey View Post
Agreed,

At least twice a month! When anyone buys a motor from a junk yard, they always leave these bolted to the frame and they get destroyed or lost. Hot rodders too, buying crate motors never come with the motor, they need these as well.

Second most requested part, coolant crossover tubes.

On a side note, i had quoted to make these thermostat housings a couple years ago, cost was less than $500.00 for them if i remember correctly, i'll wait to see what this goes for and decide if i should pursue this project.

Kurt, I think you estimated $650 for the repro not $500. Could be wrong though. Interesting sidebar on the new Bay t-housing. The quick disconnect fitting is not the original design. Has been replaced with the new design so you "all correct folks" may need to find a fitting for judging.

Last edited by Sgreg; 01-02-2009 at 12:22 PM.
Sgreg is offline   Reply With Quote