ZR-1 Net Registry Forums - View Single Post - New here, just bought '90 ZR-1

04-18-2009

You can pull the engine out with the manifolds attached. Just need to be careful. I like to pull the plenum and injector housings off to get a little more room and also helps to remove the windshield wiper motor cover.

As far as lifting. You can use the injector housing bolt holes in the head. Use and injector housing bolt with stepped washers.

As far as the harness undo all the electrical connectors and leave the harness in the car, and yes the wire that comes down to the right O2 sensor and crank sensor is tough.

04-18-2009	#33
Jeffvette Guest Posts: n/a	Re: New here, just bought '90 ZR-1 You can pull the engine out with the manifolds attached. Just need to be careful. I like to pull the plenum and injector housings off to get a little more room and also helps to remove the windshield wiper motor cover. As far as lifting. You can use the injector housing bolt holes in the head. Use and injector housing bolt with stepped washers. As far as the harness undo all the electrical connectors and leave the harness in the car, and yes the wire that comes down to the right O2 sensor and crank sensor is tough.