ZR-1 Net Registry Forums - View Single Post

JAX S50 · 09-12-2009

John, it looks like you just take your ohm meter and place the leads across the two secondary posts on the coil (the one the spark plug wire goes on) and then you need to take a reading across the primary so make something to stick under the coil where the primary slots are, I just found some thin strips of copper and cut them to fit. hope this helps. Here are my readings any thoughts ? they still look good to me
PRIMARY SECONDARY
1 & 6 01.9 5.76
3 & 2 01.3 5.83
4 & 7 01.0 5.87
5 & 8 00.8 5.80

09-12-2009	#4
JAX S50 Join Date: Jun 2009 Location: Menifee, Calif Posts: 22	Re: Question about the coils how to test? John, it looks like you just take your ohm meter and place the leads across the two secondary posts on the coil (the one the spark plug wire goes on) and then you need to take a reading across the primary so make something to stick under the coil where the primary slots are, I just found some thin strips of copper and cut them to fit. hope this helps. Here are my readings any thoughts ? they still look good to me PRIMARY SECONDARY 1 & 6 01.9 5.76 3 & 2 01.3 5.83 4 & 7 01.0 5.87 5 & 8 00.8 5.80