[QB93Z]

The two metal PCV valves plug into the two sockets in the long rubber hose. The smaller rubber piece plugs on to the top of the two PCV valves. The whole assembly is installed behind the plenum. The longer rubber piece connects to the left and right sides of the engine through metal tubing and then a right angle rubber fitting into the Injector Housings, (the left hand arrow in your pic.)

The top rubber piece connects to metal tubing (the right arrow in your pic) that runs along the driver's side of the plenum and connects to a rubber fitting under the front of the plenum.

You will meed four small hose clamps to securely connect the four openings for the long, lower rubber piece (one on each end, one on each PCV valve).

Good Luck.

Jim