ZR-1 Net Registry Forums - View Single Post

tomtom72 · 12-10-2009

If you use the OEM 90 slave cylinder, the 91 & up replacement line should fit. You may have to re-bend some of the pre-made bends....I'm not sure, sorry.

I know that when I changed out my 90 OEM slave for the replacement 91 & up slave, my 90 OEM line would not quite make the right bends down at the newer slave. I was lazy and had the newer line but was in a hurry & didn't put it in at the same time. I had to re-bend the last little bit of the old line to get it to fit.

Judging from my foray I would guess that we should do the 91 & up line + 91 & up slave cyls together?

Tom

12-10-2009	#4
tomtom72 Join Date: Dec 2004 Location: Jacksonville, FL USA Posts: 4,609	Re: Braided Clutch Line If you use the OEM 90 slave cylinder, the 91 & up replacement line should fit. You may have to re-bend some of the pre-made bends....I'm not sure, sorry. I know that when I changed out my 90 OEM slave for the replacement 91 & up slave, my 90 OEM line would not quite make the right bends down at the newer slave. I was lazy and had the newer line but was in a hurry & didn't put it in at the same time. I had to re-bend the last little bit of the old line to get it to fit. Judging from my foray I would guess that we should do the 91 & up line + 91 & up slave cyls together? Tom __________________ 1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member