[Dynomite]

Originally Posted by Paul Workman

Yeah, Jeff is right...motor is out at the moment (moment???)

It's no big deal, but like I said it was about a 30 minute job including painting. Here's some different pix. (I would have done what Pete suggested, except on my SW headers, the stock header bolt spacer interfered with the SW header tube. So this bracket attaches at one end under the front #6 port header bolt, and the other end clamps the stock hanger on the dipstick.

As you can see, a couple bends, a couple holes, and I had to grind out a divit to allow the dipstick to poke under the edge of the bracket.

The dipstick tube is rock steady and keeps the tube away from the header tubes and presents the dip stick nicely.

P.

Thanks.....that is exactly what I am looking for ...I will see if the SW headers fit tomorrow