![]() |
#1 |
Join Date: Oct 2011
Location: Springfield, IL
Posts: 117
|
![]()
Need to buy some pajamas for my baby! Any advice on best cover, best value, etc? Thanks. Nick
|
![]() |
![]() |
![]() |
#2 |
Join Date: Aug 2005
Location: Scottsdale, AZ
Posts: 2,446
|
![]() |
![]() |
![]() |
![]() |
#3 |
![]() Join Date: Jan 2009
Location: Portland Oregon metro area (Washington side)
Posts: 3,193
|
![]()
It depends on where you see the most use for it. Outside or inside?
Will it see lots of moisture or not? likelihood of it being stolen? I have two covers. One is cheap and replaced often the other is thicker and more $. Both can be ordered here: http://www.the-cover-store.com/CarCo...ror%20Pockets; The cheap on is used outside. The thicker more expensive one for inside. It'll last for years and giver extra "cush" against accidental bumps. Both are a "custom fit" so they have the little ears for the mirrors.
__________________
Scott ![]() Vett owner since 1979._It's about the car and the people |
![]() |
![]() |
![]() |
#4 |
![]() Join Date: May 2011
Location: Sydney, Australia
Posts: 2,466
|
![]()
Coverking Satin cover is the best cover for indoor use. I have used many different covers over the years. This is why I say it is the best cover on the market IMO, My cars dont get driven a lot because of my schedule, When I do use them I clean them before my next trip if necessary than wax and but the cover on, two three four weeks later no dust, no seem marks, just like a waxed it 15 minutes ago. I have Five, Three indoor and two outdoor.
![]() http://shop.corvettedepot.com/Custom...ch-CVC3-SS.htm Last edited by cvette98pacecar; 07-16-2012 at 01:43 PM. |
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Feb 2012
Location: East Peoria, IL
Posts: 55
|
![]() |
![]() |
![]() |
![]() |
#6 | |
![]() Join Date: Jan 2009
Location: Portland Oregon metro area (Washington side)
Posts: 3,193
|
![]()
somebody needs a bigger garage
![]() Scott Quote:
__________________
Scott ![]() Vett owner since 1979._It's about the car and the people |
|
![]() |
![]() |
![]() |
#7 |
![]() Join Date: Jan 2009
Location: Portland Oregon metro area (Washington side)
Posts: 3,193
|
![]()
Does anyone make a car cover with the outside looking like a corvette?
Or for that matter the outside looking like any car?
__________________
Scott ![]() Vett owner since 1979._It's about the car and the people |
![]() |
![]() |
![]() |
#8 | |
![]() Join Date: May 2011
Location: Sydney, Australia
Posts: 2,466
|
![]() Quote:
Scott you are correct, I have an ordinance where I live, no matter how big my garage is You can only house three vehicles. |
|
![]() |
![]() |
![]() |
#9 |
![]() Join Date: Feb 2012
Location: East Peoria, IL
Posts: 55
|
![]() |
![]() |
![]() |
![]() |
#10 |
![]() Join Date: May 2011
Location: Sydney, Australia
Posts: 2,466
|
![]()
I know it is an indoor cover, The only thing that I did not like about the cover was it seemed thick, When I saw it at Bloomington I was looking for a correct cover (well fitting) For my Pacecar. When I saw this cover it is custom cut so I am sure it would fit well, however it seemed like it was thick and would not breathe to me. When I asked the person at the display he did not know and he would not let me pour a little water on the one they were showing.
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|