|
11-01-2015
|
#1 |
|
Join Date: Aug 2014
Location: Montgomery TX
Posts: 263
|
Request - Master Cylinder Push Rod Diameter
Hey guys, the ZR-1 is still on the lift. Installing the RAM conversion we observed that the slave cylinder fittings make contact with the pressure plate. So I need to limit travel.
I'm going to limit travel at the MC push rod by installing a split-clamp on the rod. Just need the diameter so I order the right part. I'm waiting on a few parts to complete assembly so I won't be near the car for the next few days. Thanks for your time, Jay |
|
|
|
11-01-2015
|
#2 |
 Join Date: Dec 2003
Posts: 482
|
Re: Request - Master Cylinder Push Rod Diameter
0.291" dia. Part with reservoir. Not sure that is what you were asking for. George
Last edited by Corvettes White; 11-01-2015 at 05:14 PM. |
|
|
|
|
11-01-2015
|
#3 |
|
Join Date: Aug 2014
Location: Montgomery TX
Posts: 263
|
Re: Request - Master Cylinder Push Rod Diameter
That's it, the MC push rod. Thanks, going to try and put a small split clamp around the shaft near the eye to limit hydraulic release bearing (HBR) travel.
 Got a 7mm steel and a 1/4" teflon split clamp. Thanks again, Jay |
|
|
|
|
11-01-2015
|
#4 |
|
Join Date: Dec 2003
Posts: 482
|
Re: Request - Master Cylinder Push Rod Diameter
Welcome.
|
|
|
|
 |
|
|
Linear Mode
