MagnaFlow Exhaust Fitment - ZR-1 Net Registry Forums

XfireZ51 · 04-23-2010

I decided to modify the Magnaflow exhaust I got so that the mufflers would not hang as low as previously. Did a few mods, (thanks Al, =Jeff=) and below are some pics of the revised look. Basically, in order for the tips to be aligned with the face of the rear fascia, the muffler can itself would interfere with the rearmost chassis rail. In addtion, the muffler hangars were too high off the muffler body to allow the muffler to tuck up into the exhaust cutout. I pushed the mufflers back further, so they are currently slightly recessed into the exhaust cutout but now they tuck up nicely without the entire muffler can hanging like some herniated ricer car.
Took pics while car was getting re-aligned due to lowering of rear end

Think this looks much better.

04-23-2010	#1
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,686	MagnaFlow Exhaust Fitment I decided to modify the Magnaflow exhaust I got so that the mufflers would not hang as low as previously. Did a few mods, (thanks Al, =Jeff=) and below are some pics of the revised look. Basically, in order for the tips to be aligned with the face of the rear fascia, the muffler can itself would interfere with the rearmost chassis rail. In addtion, the muffler hangars were too high off the muffler body to allow the muffler to tuck up into the exhaust cutout. I pushed the mufflers back further, so they are currently slightly recessed into the exhaust cutout but now they tuck up nicely without the entire muffler can hanging like some herniated ricer car. Took pics while car was getting re-aligned due to lowering of rear end Think this looks much better. Last edited by XfireZ51; 04-23-2010 at 05:18 PM.