Headers & exhaust

[Schrade]

Originally Posted by TomZR1

I know what you guys are thinking ,install them your self ,hell no it looks like a pain in the azz,not going to start something that i can't finish.

I think you can do this with 1 hand. If you we're gonna' do the PS hoses, you can do the pipes...

[edram454]

they look great!! You will love these and they will tuck in nicely under your car. Congratulations on your purchase.

ed ramos #3028

[project c4]

Originally Posted by TomZR1

got my exhaust,they look awsome!!!!!!!!

If you don’t mind me asking... what diameter is the y-pipe where it goes into the resonator ?

[TomZR1]

Don't know, I'll measure & let know

[project c4]

thank you sir

[TomZR1]

11inches

[project c4]

thank you very much

[Tony Davila]

Originally Posted by WARP TEN

George, this is exactly what I went through. Primarily Corsas over the years but just got tired of the Loud. I have headers, no cats and last year had Marc reinstall my stock '95 system from the headers back. The only difference is I had him add electric QTP cutouts and I installed a rocker switch hidden under the carpet on the right side of the console. The only issue is I had to sacrifice the spare tire carrier. On longer trips away from home I carry the spare in the back. I added small tips to direct the exhaust to the side. So far I like the setup a lot. It is stock quiet when I want and when open I can scare children and pets and set off car alarms. I normally run slightly open for a little rumble.--Bob

This what is inside of your stock mufflers. Just in case you or anybody else was wondering. 2.75" shrinks down to 2.25" at the outlet. No wonder muffler swap gains good power improvement. I'm doing the same mod with my B&Bs.

[Karl]

Originally Posted by TomZR1

11inches

How large is the inlet pipe where the two pipes meet and enter the resonator... 3.5"??? Can't be 11"

[We Gone]

Originally Posted by pushrod-v8

How large is the inlet pipe where the two pipes meet and enter the resonator... 3.5"??? Can't be 11"

Just checked mine, 3.5" across, 11" if you wrap the tape around the pipe.