backup lights - ZR-1 Net Registry Forums

8388 · 09-23-2004

You have to move the slave cylinder out of the way in order to get to it, only two nuts hold it in place. I had to cut up a 12 point socket and weld it unto a wrench, because you have to reach inward towards the tranny in order to get to the switch. I should start marketing this tool, since it makes the job a breeze, and there's literally thousands of these switches out there, that are about to fail.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-23-2004	#2
8388 Join Date: Dec 2003 Location: Texas Posts: 12	You have to move the slave cylinder out of the way in order to get to it, only two nuts hold it in place. I had to cut up a 12 point socket and weld it unto a wrench, because you have to reach inward towards the tranny in order to get to the switch. I should start marketing this tool, since it makes the job a breeze, and there's literally thousands of these switches out there, that are about to fail.