B&B Fusion: First Look - Page 5 - ZR-1 Net Registry Forums

Locobob · 03-19-2012

It would be nice if B&B would rotate the actuator upward a bit, that would decrease its exposure to debris and make it less visible from the rear. There is room to do this.

Locobob · 03-19-2012

Quote:

Originally Posted by KGV

Would it be possible to switch the mufflers to the opposite sides so that the actuator is on the inside? It looks like if the tire picked up stones, they could impact the actuator.

Ken

[/QUOTE]

Anything is possible.... but switching sides with the muffler assemblies would be a major undertaking. You'd have to cut off the pipes that are welded to the backs of the mufflers and then splice them back together on the other side - then try to line everything up again. It would be a whole lot easier to just make a little debris shield.

PhillipsLT5 · 03-19-2012

If B&B had taken me up on my offer to use my car to fab this up, they may have come up with a better set up, They also could of looked at Marc's or the FBI's set up for ideas

cvette98pacecar · 03-20-2012

Quote:

Originally Posted by PhillipsLT5

If B&B had taken me up on my offer to use my car to fab this up, they may have come up with a better set up, They also could of looked at Marc's or the FBI's set up for ideas

I just saw Paul car and I didn't see any type of exhaust baffle. But I wasnt looking either.

tf95ZR1 · 03-20-2012

It seems to be hit and miss with B&B.
First time I called to order a 3" X pipe they said no,
have to buy entire system and/or trade in the resonator.
Next call, I got my B&B X pipe. Not cheap....

Locobob · 03-21-2012

Well todays dyno session didn't go to well. Peak HP at 335 was almost identical to the baseline runs and below peak the car was down on power throughout the rpm range. The car is stock except for the cat back. I'm pretty sure it has nothing to do with the exhaust as I've never seen a Z lose low or mid range due to big pipes. After the fact Steve realized he had left the defogger on... which turns the A/C compressor. I'm not sure if that could be it or not. I know the ecm automatically disengages the A/C under either WOT or at a certain RPM but I don't recall the details... anyone remember how that works?

XfireZ51 · 03-21-2012

Robert,

A/C is off at 70% TPS and/or 5000rpm. So at a WOT run A/C would be a non issue for Peak Power.

Locobob · 03-21-2012

Quote:

Originally Posted by XfireZ51

Robert,

A/C is off at 70% TPS and/or 5000rpm. So at a WOT run A/C would be a non issue for Peak Power.

Yeah that's what I thought..... wonder if he just got some lousy gas or something. Same dyno as before and atmospherics were really close. Hmmmm

tf95ZR1 · 03-21-2012

Key on?

:willy:

I know, wouldn't be that high
without secondaries.

XfireZ51 · 03-21-2012

Fro the vid it sounds like its taking a while to get up there.

03-19-2012	#41
Locobob Join Date: Jan 2004 Location: Portland, OR Posts: 1,047	Re: B&B Fusion: First Look It would be nice if B&B would rotate the actuator upward a bit, that would decrease its exposure to debris and make it less visible from the rear. There is room to do this. __________________ Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368

03-19-2012	#43
PhillipsLT5 Join Date: Aug 2005 Location: Scottsdale, AZ Posts: 2,446	Re: B&B Fusion: First Look If B&B had taken me up on my offer to use my car to fab this up, they may have come up with a better set up, They also could of looked at Marc's or the FBI's set up for ideas

03-20-2012	#45
tf95ZR1 Join Date: Aug 2005 Location: Northridge, CA Posts: 1,458	Re: B&B Fusion: First Look It seems to be hit and miss with B&B. First time I called to order a 3" X pipe they said no, have to buy entire system and/or trade in the resonator. Next call, I got my B&B X pipe. Not cheap....

03-21-2012	#46
Locobob Join Date: Jan 2004 Location: Portland, OR Posts: 1,047	Re: B&B Fusion: First Look Well todays dyno session didn't go to well. Peak HP at 335 was almost identical to the baseline runs and below peak the car was down on power throughout the rpm range. The car is stock except for the cat back. I'm pretty sure it has nothing to do with the exhaust as I've never seen a Z lose low or mid range due to big pipes. After the fact Steve realized he had left the defogger on... which turns the A/C compressor. I'm not sure if that could be it or not. I know the ecm automatically disengages the A/C under either WOT or at a certain RPM but I don't recall the details... anyone remember how that works? __________________ Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368

03-21-2012	#47
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,686	Re: B&B Fusion: First Look Robert, A/C is off at 70% TPS and/or 5000rpm. So at a WOT run A/C would be a non issue for Peak Power.

03-21-2012	#49
tf95ZR1 Join Date: Aug 2005 Location: Northridge, CA Posts: 1,458	Re: B&B Fusion: First Look Key on? :willy: I know, wouldn't be that high without secondaries.

03-21-2012	#50
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,686	Re: B&B Fusion: First Look Fro the vid it sounds like its taking a while to get up there.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode