Warped Injector Housings - ZR-1 Net Registry Forums

LGAFF · 05-06-2014

Well, I tried checking the gasket compression with a new set of gaskets...could not see a mark...but looks like that was because they are new. Took some Gorilla tape and put it down, the Inj Hs are leaving deep marks on the tape.....so Gorilla Tape is 1/4 the thickness of Jerrys Gaskets.....I think I am good....any thoughts.

I believe the warp is in the center of the IH, so if you tighten down one side of the IH is amplifies the warp

I am think get them milled and ready to go

05-06-2014	#7
LGAFF Join Date: Mar 2007 Location: Crystal Lake, IL Posts: 7,180	Re: Warped Injector Housings Well, I tried checking the gasket compression with a new set of gaskets...could not see a mark...but looks like that was because they are new. Took some Gorilla tape and put it down, the Inj Hs are leaving deep marks on the tape.....so Gorilla Tape is 1/4 the thickness of Jerrys Gaskets.....I think I am good....any thoughts. I believe the warp is in the center of the IH, so if you tighten down one side of the IH is amplifies the warp I am think get them milled and ready to go __________________ LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode