|
![]() |
#1 |
Join Date: Apr 2008
Location: Nevada
Posts: 16
|
![]()
I would lower both the front and rear for consistancy. By bringing the front end closer to the ground, less air should get under the car. The center of gravity should be 1" lower which should theoretically make handling better. Does anyone have an idea about alignment - stock or something else?
|
![]() |
![]() |
![]() |
#2 |
Join Date: Dec 2007
Location: Fremont, CA
Posts: 3,093
|
![]()
You do have to get the car aligned after its been lowered and as far as taking the speed up to the a$$ pucker zone,not in my car.Get it up to about 110,hit a bump and it gets pretty scary.Theres very little rebound in the suspension so you get thrown around abit at speed but my car will never be raised back up to stock haight,not while I own it.A lowered car isnt for everybody,most seem to think its a waste but thats just the way I like my cars.I went with the addjustable spring from VB-P mainly because I didnt want to cut my stock spring.I avoid speed -Mountains- and steep driveways.
|
![]() |
![]() |
![]() |
#3 |
![]() Join Date: Dec 2004
Location: Luling, TX
Posts: 97
|
![]()
I believe that if the car is lowered equally front and back, then the rearend will be light at 180. I have done that and to get the rearend to stay where you want it, we had a front to rear rake of 1/2 ". That is measured from the frame just behind the front wheel to just in front of the rear wheel. The car had coilovers and was very low to the ground with very stiff suspension. However, that setup was stable at 200 mph. With stock suspension and only slight rake, car moved around at 170+. At 180, it was interesting on a rough road. Depends on what you are trying to do. Open Road Racing is alot of high speed. Driving on the street or on a road course where you don't get above 150, probably that lightness in the rear would be offset by better balance of the car. In that slower speed area, the problem is the load unload side to side movement of the suspension and that can be a real problem, especially on a rough track such as Texas World Speedway. If you are serious about track racing or ORR, then my recommendation is coilovers. Most of the time, I stay out of these discussions as what I wanted out of my car is not what most people would be happy with. I drove my car on the street but most people would not like how it sounded or felt like inside the car. Bob and I were about the only people that didn't mind as we are both deaf anyway. #364 was setup to go as fast as I could make it go with limited rwhp and almost no thought given to comfort.
Curtis |
![]() |
![]() |
![]() |
#4 |
Join Date: Jun 2006
Location: Thunderbolt, Ga.
Posts: 253
|
![]()
What happened to #364?
|
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Dec 2004
Location: Luling, TX
Posts: 97
|
![]()
After 4 great years of racing, #364 met an imoveable object at about 50 mph. I loaned her to another ZR-1 owner to drive in a "safe" low speed autocross. Turned out to be not so safe for the car. At least she went out racing.
Curtis |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|