Solution to my misfire problem was a crimped wire to # 1 Injector - Page 2 - ZR-1 Net Registry Forums

QB93Z · 05-27-2011

I have been trouble shooting a misfire and lean fuel problem on my 1993 ZR-1 for a while. I finally found and corrected the problem.

The wires to #1 primary injector got pinched between the plenum and the injector housing on a previous plenum pull and crushed the insulation on the wires and blew the INJ#1 fuse. I repaired the insulation, but missed that the wire was damaged about an inch further up the insulation. The result was that #1 Primary and Secondary Injectors were not operating.

Here are some pics of the final repair:

Final result, QUASARZ is running better than ever now that I can get to see the result of Phil's Plenum and IH porting.

Jim

05-27-2011	#1
QB93Z Join Date: May 2007 Location: Westminster, Maryland Posts: 3,684	Solution to my misfire problem was a crimped wire to # 1 Injector I have been trouble shooting a misfire and lean fuel problem on my 1993 ZR-1 for a while. I finally found and corrected the problem. The wires to #1 primary injector got pinched between the plenum and the injector housing on a previous plenum pull and crushed the insulation on the wires and blew the INJ#1 fuse. I repaired the insulation, but missed that the wire was damaged about an inch further up the insulation. The result was that #1 Primary and Secondary Injectors were not operating. Here are some pics of the final repair: Final result, QUASARZ is running better than ever now that I can get to see the result of Phil's Plenum and IH porting. Jim