ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > Search Forums

Showing results 1 to 25 of 250
Search took 0.02 seconds.
Search: Posts Made By: Marc Haibeck
Forum: C4 ZR-1 Technical Postings 2 Weeks Ago
Replies: 5
Views: 648
Posted By Marc Haibeck
Re: Priming Oil System?

You should not use the "flood clear mode", that is pedal to the floor while cranking the LT5 engine. Doing so may cause a huge backfire.
Forum: C4 ZR-1 Technical Postings 3 Weeks Ago
Replies: 25
Views: 15,105
Posted By Marc Haibeck
Re: Dreaded Upper Cam Chain Guide Failure

I have never seen a chain wear through a lower guide facing.

Other more likely sources of iron particles are the cams, lifters, and crankshaft. You probably inspected the cams and lifters when...
Forum: C4 ZR-1 Technical Postings 3 Weeks Ago
Replies: 25
Views: 15,105
Posted By Marc Haibeck
Re: Dreaded Upper Cam Chain Guide Failure

The pictures in my article are of of the mounting plate for the snubber.

The marks on the tops of the chain links in the picture look normal to me.

Marc
Forum: C4 ZR-1 Parts For Sale / Wanted 04-03-2025
Replies: 0
Views: 3,728
Posted By Marc Haibeck
WTB Dana Spicer 4.10 Gear Set

Dana Spicer PN 76581-5X or 76581X
or
Isuzu and Honda PN 8-97179-928-0
Forum: C4 ZR-1 Technical Postings 04-02-2025
Replies: 25
Views: 15,105
Posted By Marc Haibeck
Re: Dreaded Upper Cam Chain Guide Failure

Here is some information about upper chain facings coming loose. Note that this article is from 2008. I have seen about four more failures since then. We have found them when we remove the cam the...
Forum: C4 ZR-1 Technical Postings 11-12-2024
Replies: 7
Views: 5,139
Posted By Marc Haibeck
Re: Knocking sound and disconnected hose, Help!

You can use an ohm meter to test for a short circuit on a wire that is hidden. With the battery disconnected, each of the fuel injector drive circuits should measure 18 to 22 ohms to ground. A...
Forum: C4 ZR-1 Technical Postings 11-11-2024
Replies: 7
Views: 5,139
Posted By Marc Haibeck
Re: Knocking sound and disconnected hose, Help!

From your overall detailed description of the running condition I wonder if a fuel injector wire is pinched under the plenum. The front primary fuel injectors on both banks are the most susceptible...
Forum: C4 ZR-1 Technical Postings 09-23-2024
Replies: 18
Views: 18,502
Posted By Marc Haibeck
Re: Crank No-Start/Idle 91 ZR-1

The future of your ECM is not looking good. Maybe it has a poor internal connection. Have someone bang on the ECM with their hand while you are cranking the engine. Beyond that, try to find another...
Forum: C4 ZR-1 Technical Postings 09-22-2024
Replies: 18
Views: 18,502
Posted By Marc Haibeck
Re: Crank No-Start/Idle 91 ZR-1

Try these two suggestions.

Is there a VATS lockout? With the door open and the ignition key off the Security light should be blinking. Close the door and try to start the engine. Is the Security...
Forum: C4 ZR-1 Technical Postings 05-27-2024
Replies: 15
Views: 23,565
Posted By Marc Haibeck
Re: Electrical question: is this supposed to be here

A lower pitch click could be from the cams snapping over center due to slack in a secondary timing chain. There must be at least 10 psi of oil pressure to keep the chain tensioned.

The same sound...
Forum: C4 ZR-1 Technical Postings 05-26-2024
Replies: 15
Views: 23,565
Posted By Marc Haibeck
Re: Electrical question: is this supposed to be here

The battery needs to supply 12.5 volts or more when the hot no start condition is present. Check the battery voltage with the ignition off and the doors closed.

The clutch switch is a suspect. An...
Forum: C4 ZR-1 Technical Postings 04-03-2024
Replies: 22
Views: 10,238
Posted By Marc Haibeck
Re: Continuing angst... headers today...

You are referring to a posting from a six years ago. The current version, made in the past four years or so, of Stainless Works headers does not interfere with the steering shaft. They currently make...
Forum: C4 ZR-1 Technical Postings 06-27-2022
Replies: 6
Views: 1,676
Posted By Marc Haibeck
Re: Best Place to Get Backup Light Switch?

Lectric Limited has the switch. PN 10159402.
https://www.lectriclimited.com/
Forum: C4 ZR-1 Technical Postings 04-03-2022
Replies: 7
Views: 5,499
Posted By Marc Haibeck
Re: What spark plug wires are these?

They are solid core wires. I recall that several sets were installed in a hotel parking lot at a BG Gathering in about 2005. Non-resistor BRU sparkplugs were also installed. The combination caused...
Forum: C4 ZR-1 Technical Postings 09-12-2021
Replies: 60
Views: 12,346
Posted By Marc Haibeck
Re: New 3" Exhaust Installation

It's easy to control the valves with an RPM switch. Use Summit Racing PN SUM-830453. $50. Connect it to the B&B vacuum solenoid. Then you can set it to automatically open the valves at, let's say...
Forum: C4 ZR-1 Technical Postings 08-09-2021
Replies: 13
Views: 2,993
Posted By Marc Haibeck
Re: DIC Bulb Location

The 'ABS Active' indication was first implemented in '91. It will turn on for a second during the pump self test when the car goes to about 8 mph following key on. In '91 a relay was added to drive...
Forum: C4 ZR-1 Technical Postings 07-11-2021
Replies: 33
Views: 6,170
Posted By Marc Haibeck
Re: I guess it wouldn't be a ZR-1 without an oil leak.

The '92 - '95 sensor fits without the bushing.

Many people have replaced the oil temperature sensor and have been disappointed. The scale on the gauge is non-linear. When the needle is pointed at...
Forum: C4 ZR-1 Technical Postings 06-05-2021
Replies: 7
Views: 1,386
Posted By Marc Haibeck
Re: AC compressor question

Grounding pin C16 on the ECM will directly activate the compressor clutch relay. If the compressor runs, your problem is that the ECM is not receiving an "AC Request" signal.
Forum: C4 ZR-1 Technical Postings 05-22-2021
Replies: 8
Views: 7,304
Posted By Marc Haibeck
Re: Diff fluid change

The C4 Corvette service manual does not specify a lubricant change interval for the differential.

Debris gets shed into the lubricant during the break-in period. I like to replace the lubricant...
Forum: C4 ZR-1 Technical Postings 04-05-2021
Replies: 10
Views: 2,576
Posted By Marc Haibeck
Re: corsa exhaust

I'm not sure, but I believe that the right side flange was eliminated at the '92 1/2 model year point.

In my opinion, GM used the low restriction mufflers that they developed for the '92 LT1 as...
Forum: C4 ZR-1 Technical Postings 04-04-2021
Replies: 10
Views: 2,576
Posted By Marc Haibeck
Re: corsa exhaust

'90 - '95 has a ball fitting on the left side.
'90 - '92 has a three bolt flange with a gasket on the right side.
'93 - '95 has a 2 3/4" slip fit on the right side.

A '93 - '95 exhaust system...
Forum: C4 ZR-1 Technical Postings 03-28-2021
Replies: 13
Views: 2,203
Posted By Marc Haibeck
Re: Brake pump

In the US the Dorman master cylinder is available at RockAuto.com. I know that recently a ZR-1 owner in France was able to get parts from Rock Auto. Hopefully you can.
Forum: C4 ZR-1 Technical Postings 03-27-2021
Replies: 13
Views: 2,203
Posted By Marc Haibeck
Re: Brake pump

Hi,

I have seen this several times. The master cylinder can transfer fluid from the front reservoir to the rear reservoir when there is an internal leak in the cylinder.

For replacement we use...
Forum: C4 ZR-1 Technical Postings 03-14-2021
Replies: 7
Views: 1,704
Posted By Marc Haibeck
Re: Ecklers speedometer module - help needed

Yes Matt. The yellow wire on the speedometer sensor is the other end of the yellow speedometer wire on the ECM.
Forum: C4 ZR-1 Technical Postings 02-15-2021
Replies: 7
Views: 1,704
Posted By Marc Haibeck
Re: Ecklers speedometer module - help needed

You cut the yellow wire at the ECM connector. The output of the correction module goes into the ECM. The ECM transmits the speed to rest the car.
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -4. The time now is 05:39 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025