[Dynomite]

What is the input and function of the starter enable in the Central Control Module (90-92)?
The CCM function activates the Starter Enable Relay (90-92)?

Then we have the higher current load passing through the Clutch Start Switch (90-92) which we reduce that current load using an additional Relay which provides a much shorter and unencumbered path between the Battery and Starter Solenoid.

On the 90-92 we eliminate the ignition switch path between the battery and Starter Solenoid as well using the New Relay.
If we installed the New Relay on the 93-95 we would be using direct current between Battery and Starter Solenoid not relying on current passing through the Ignition Switch (in that regard the same benefit as on a 90-92).