A few ECM Questions...

[VetteVet]

Ron,

If you're looking for the female connectors (I assume to make a conversion harness), I have searched and have not found anything out there. If you were to take a bad ECM and desolder the connectors from the ECM main board, you would have something that would plug into the engine harness, but would not really be suitable for a conversion harness.
If that's not where you're headed, I apologize. Through my research, I have come to the conclusion that Delphi never made any female versions of those connectors other than the ones used for the ECM circuit boards. You could give Mike, the owner of EFI Connection, a call. He may be able to help.

Jep

[-=Jeff=-]

Originally Posted by VetteVet

Ron,

If you're looking for the female connectors (I assume to make a conversion harness), I have searched and have not found anything out there. If you were to take a bad ECM and desolder the connectors from the ECM main board, you would have something that would plug into the engine harness, but would not really be suitable for a conversion harness.
If that's not where you're headed, I apologize. Through my research, I have come to the conclusion that Delphi never made any female versions of those connectors other than the ones used for the ECM circuit boards. You could give Mike, the owner of EFI Connection, a call. He may be able to help.

Jep

Yes but for a conversion harness, he could use 2 sets of PCB connectors and wire them in a ECM box, then create another set to plug in to the box then the new ECM

just a thought