TOP END REFINISHING

[Schrade]

Originally Posted by WARP TEN

Sounds like a very familiar path, but I trust to ultimate sucess --Bob

I'll take that in writing Sir - pen is on the windshield

So let's try again; the RIGHT way.

Pull the D side rail; oil the rail crossover D side inlet / outlet



fit (I don't know how far I thought I was gonna' go, with that screw in place - where's Houdini when ya' need him? ) AND KEEP YER GRUBBY FINGERS OFF OF THE CLEAN RAIL / INJ PORTS!



drive



clip

[Schrade]

tighten clip



grease on rail holddown bolts



Will the same type connector in here, fit inside the CC vent crossover tube, if I cut the tube where I put the clamp?