Shift light and stealth mounting recommendations?

[FU]

Here ya go :

http://cgi.ebay.com/ebaymotors/Rapto...item1c1144415e

[Daniel_Mc]

I used the Harlan shift light in the A/C vent and it works great. Looking at around 50 or so.

http://www.harlan-engineering.com/st...hiftlight.html

Daniel

[Nacho_ZR1]

Originally Posted by FU2

Here ya go :

http://cgi.ebay.com/ebaymotors/Rapto...item1c1144415e

Done. "Carlos, your payment of US $110.95 has been processed by PayPal"

Now, any tips on getting the A/C vent off? Do I have to take apart the whole console or will a simple screw driver be all that I need...

[FU]

Originally Posted by Nacho_ZR1

Now, any tips on getting the A/C vent off? Do I have to take apart the whole console or will a simple screw driver be all that I need...

Phllips screw driver and the vent pulls out.

[Nacho_ZR1]

Originally Posted by FU2

Phllips screw driver and the vent pulls out.

Now thats something I can handle

[Coupe89]

http://www.hashmarks.com/ShiftLight/index.html

[Nacho_ZR1]

Originally Posted by Coupe89

http://www.hashmarks.com/ShiftLight/index.html

[HAWAIIZR-1]

Originally Posted by Coupe89

http://www.hashmarks.com/ShiftLight/index.html

This is the shift light I bought and installed; it works like a champ and very easy following the instructions here.

[Paul Workman]

I used a wire from a coat hanger to" fiche" behind the kick panned to the connector on the firewall (above and to the left of where the drivers left ankle would normally be - tying into the tack signal wire. The Raptor sits behind the A/C vent. Very stealthy...until it comes on. No trouble seeing it then!

P.

[XfireZ51]

Originally Posted by Paul Workman

I used a wire from a coat hanger to" fiche" behind the kick panned to the connector on the firewall (above and to the left of where the drivers left ankle would normally be - tying into the tack signal wire. The Raptor sits behind the A/C vent. Very stealthy...until it comes on. No trouble seeing it then!

P.

Paul,

It would be easier and more convenient to just use diag harness connector on drivers side and pull switched power and tach signal from there. Add a ground to the MAP sensor bolts then snake wires between A pillar and IP pad.