Seat Track - ZR-1 Net Registry Forums

vettn71 · 11-20-2011

Well, I am a practictioner of the BFH mechanical maintenance method, but I don't want to bust this thing up, if I can help it. There was one C-clip on the one smaller cross-shaft and the two cotter keys. It's loose, but won't separate. What am I missing? The photo shows where I'm at.

Jim

Ccmano · 11-20-2011

The only thing holding it together now is the motor drive shaft tubes. If you look at the motor there are two screws between the three tubes where they attach to the motor. Remove those screws and the two halves should come apart. Remove the bolts that hold the transmission to the frame, I think there are three that go through the center of the case. The transmission case is is riveted together along the outside, those need to be drilled out to separate the halves.
H

11-20-2011	#2
Ccmano Join Date: Jun 2006 Location: Sparks, NV Posts: 2,843	Re: Seat Track The only thing holding it together now is the motor drive shaft tubes. If you look at the motor there are two screws between the three tubes where they attach to the motor. Remove those screws and the two halves should come apart. Remove the bolts that hold the transmission to the frame, I think there are three that go through the center of the case. The transmission case is is riveted together along the outside, those need to be drilled out to separate the halves. H