ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 General Postings

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-14-2012   #11
VetteMed
 
Join Date: Mar 2009
Location: Orlando, FL
Posts: 1,816
Default Re: Update on my hi-miler Z project

Next step is the removal of the throttle plate shaft and bearing assembly.

View of the shaft, in the intake port



View of the external portion of the shaft



A socket is fit over the threaded end of the shaft (I used a 5/8"). The key is that the hex end of the socket must be large enough to accomodate the bearing as it's pulled out of the cylinder head, yet small enough to fit flush on the flat surface surrounding the bearing.



A fender washer is then placed over the threaded end of the shaft that protrudes through the square end of the socket



The actuator arm nut is then threaded back on to the shaft, and carefully tightened against the washer, which will then pull the entire bearing assembly out of the head. A needlenose pliers, with a rag or towel as cushion, is used to grasp the throttle shaft to prevent rotation.



Done! 7 more to go!

VetteMed is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:16 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025