Carter, new part,I think.

[Dynomite]

Originally Posted by efnfast

Sorry Cliff, didn't mean to pick on your solution. If there is nothing commercially available, Carter MUST be able to knock something out. I bet he could even carve LT-5 or something in it.

Ha.....this happened to me before when I got creative but not up to snuff and Carter came up with something much better looking.....so I just create and fool around and wait for carter to make it right

Here is a REAL Example of KLUDGE if our friend is listening

Carter.....Dude.... As you can see I did not leave much rubber hose to work with but enough for some kind of plug.

[carter200]

Dyno,
I'll work some magic and replace that sow's ear......

[carter200]

I just finished the Bypass Plug for efnfast. In the mail to him tomorrow and hopefully he'll post up a pic before and after. Working on front sway bar relocation brackets, LT5 rear plate, billet throttle line brackets then a project for GC.

[WVZR-1]

I would think something similar to this one. Anything short of "barbed" similar to this I think might fall short. This is maybe an "incorrect" dimension but a correct ID I never did see mentioned. This one is 3/8".

[XfireZ51]

I run the hoses as if they were operational.

[Dynomite]

Originally Posted by carter200

I just finished the Bypass Plug for efnfast. In the mail to him tomorrow and hopefully he'll post up a pic before and after. Working on a LT5 rear plate next then a project for GC.

We need a photo and description of how it fits.......and size

Originally Posted by WVZR-1

I would think something similar to this one. Anything short of "barbed" similar to this I think might fall short. This is maybe an "incorrect" dimension but a correct ID I never did see mentioned. This one is 3/8".

The Hose ID is 3/8 inch fitting on a 3/8 inch OD pipe nipple.
You will find the 3/8 inch Aluminum Barbed Hose Plug here....... 3/8 inch Barbed Hose Plug

Originally Posted by XfireZ51

I run the hoses as if they were operational.

What else are you faking

I run my ZR-1 as if it were stock around CA Highway Patrol......

[efnfast]

Carter stuff just arrived. My plug, oil filter cover, oil filler cover, power steering and brake fluid. Gimme a minute, I'll get it installed.

[carter200]

Originally Posted by efnfast

Carter stuff just arrived. My plug, oil filter cover, oil filler cover, power steering and brake fluid. Gimme a minute, I'll get it installed.

PM me with your findings.....

[efnfast]

I used a Gates heat shrink for the plug. Looks the nuts. This is a must if you've eliminated the tb coolant.

[Dynomite]

Originally Posted by efnfast

Carter stuff just arrived. My plug, oil filter cover, oil filler cover, power steering and brake fluid. Gimme a minute, I'll get it installed.

Do you have a nice photo of that TB Coolant Plug Carter came up with I been waiting for

And Carter.....Just look at my thread and make a Billet Oil Dip Stick Handle.....there is enough information there to crank (excuse me....turn) one out I am sure.....

AMSOIL 10W-40 Etched in Red Letters

See Item #3 LT5 Lubrication Tricks