Any fix for a worn 91 ashtray lid?

[Young1]

Look for a used replacement. Call Mirrock Corvette. They support our forum. Mark will know if the manual or automatic consoles have the same lid. Then you know it will match.

[Matt B]

Good point, thank! I'll give him a shout!
Also I realized ZIP has a replacement, too. Any experience with that one? https://www.zip-corvette.com/90-91-m...rim-plate.html

[Corvette95]

Originally Posted by conesare2seconds

Very cool. I?ll watch for it. I spent big on a NOS radio bezel a few years back and it is getting sticky, to my dismay. Never had that problem on other 94-96es I owned. Thank you!

***NEVER**** use ANY interior / cleaner protector on bezel, shifter or dash/door trim (like window switches, air vents) a very mild water and non spot car wash soap is your only option), then lightly pat dry with micro fiber/ or better yet no lint towel.

[secondchance]

90 or 91, auto or manual, all have the same ash tray door/lids.

[Corvette95]

Originally Posted by Matt B

Good point, thank! I'll give him a shout!
Also I realized ZIP has a replacement, too. Any experience with that one? https://www.zip-corvette.com/90-91-m...rim-plate.html

unfortunately the entire run of these shifter plates for a manual car was produced with an error where the shift boot fits, and the factory boot won't fit, it has to be rigged and there is no good way to rig it. Look at bottom of small print and it tells you this, this is the same part that all of the places sell, so it is just not this vendor.

[GOLDCYLON]

Originally Posted by tf95ZR1

Rubbery stuff is called "Dulso"

https://www.zr1.net/forum/showthread...console+rubber

There is no Dulso on a 91 Ted

[GOLDCYLON]

Originally Posted by Corvette95

I am going to be offering to refurbish members radio bezels and shift plates ( including the lettering on the ZR-1 bezel). I am still in the final phase of testing and have done a couple of members here that seem to be satisfied. The coating I am putting on the late bezels and plates isn't dulso but it has the correct feel to it. Haven;t had one go through NCRS yet. Fairly certain my 90 and 91 's would fly though.

I would like to see this when done. I had a hell of a time getting the painting correct on top of my carbon fiber.

[dandt67]

Used this paint from Mid America Motorworks on my1991 ash tray lid...It was a perfect match. It no longer shows up on their website, but you might give them a call and see if they can still provide some.