Stainless Works headers - ZR-1 Net Registry Forums

We Gone · 05-06-2008

Jeff,

I just got this set from SSW on 3/28 ordered them the first of Feb. took about a month as they had to make them and send them out for coating. Got around to putting them on 2 weeks ago. Everything went normal as far as header installs go. The fit was good all the bolt holes lined up very nice. The fit near the steering shaft was close but still had about 3/8 inch of clearance. As far as the left motor mount they do touch the insulation but nothing more. On the right side the only close spot is the frame rail with about a 1/16 inch clearance. Looks like someone did not get the jig set up right on the set you are working with.

05-06-2008	#1
We Gone Join Date: Apr 2004 Location: Atlanta, GA Posts: 2,170	Re: Stainless Works headers Jeff, I just got this set from SSW on 3/28 ordered them the first of Feb. took about a month as they had to make them and send them out for coating. Got around to putting them on 2 weeks ago. Everything went normal as far as header installs go. The fit was good all the bolt holes lined up very nice. The fit near the steering shaft was close but still had about 3/8 inch of clearance. As far as the left motor mount they do touch the insulation but nothing more. On the right side the only close spot is the frame rail with about a 1/16 inch clearance. Looks like someone did not get the jig set up right on the set you are working with.