Radiator Shroud - ZR-1 Net Registry Forums

tomtom72 · 03-30-2006

I looked at my 90's shroud and I believe that is the case. I looked up the write up over at the NetRegistry site and it says the same thing about getting past the A/C lines. I remember looking to do the job last yr but bailed out after wrestling with the 7mm side screws. Now I'm going to do it this yr as I have to swap oil lines & T-stat & cooling hoses. I figure I should do the radiator clean up now as some of the stuff will be out of the way.

I'm not looking forward to cutting the shroud but if that's the only way short of loosing the refrigerant then the shroud gets cut. Lesser of two evils type of thing.

03-30-2006	#2
tomtom72 Join Date: Dec 2004 Location: Jacksonville, FL USA Posts: 4,609	Re: Radiator Shroud I looked at my 90's shroud and I believe that is the case. I looked up the write up over at the NetRegistry site and it says the same thing about getting past the A/C lines. I remember looking to do the job last yr but bailed out after wrestling with the 7mm side screws. Now I'm going to do it this yr as I have to swap oil lines & T-stat & cooling hoses. I figure I should do the radiator clean up now as some of the stuff will be out of the way. I'm not looking forward to cutting the shroud but if that's the only way short of loosing the refrigerant then the shroud gets cut. Lesser of two evils type of thing. __________________ 1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member